Step Type:

Drag to rearrange

This Step is only meant for the Hybrid and IDEX builds if you are building a V-Core 4 CoreXY skip this Step.

Route the L Stepper motor cable as shown. (This will be the X stepper in the idex)

Route the R Stepper motor cable as shown. (This will be the DC stepper in the idex)

Connect the Left [L] Stepper motor cable to the first slot available on the Octopus Board, counting from the bottom.

Connect the Right [R] Stepper motor cable in the sixth slot available on the Octopus Board, counting from the bottom.

The stepper motor wire colour order does not matter if the cable was supplied in the V-Core 4 kit.

Use three wire clips prepared in Step 46 at the marked locations. Evenly distribute them along the extrusion.

Your contributions are licensed under the open source Creative Commons license.