Editing Step 49 —
CoreXY - Stepper motors

Step Type:

Drag to rearrange

Route the Right [R] Stepper motor cable as shown.

Route the Left [L] Stepper motor cable as shown.

Connect the Left [L] Stepper motor cable to the lowest slot available on the Octopus Board

Connect the Right [R] Stepper motor cable to the second lowest slot available on the Octopus Board

Make sure the connectors are oriented correctly with their sockets. The "key" on the connector should align with the "gap" on the sockets.

The stepper motor wire colour order does not matter if the cable was supplied in the V-Core 4 kit.

Use six wire clips prepared in Step 46 at the marked locations. Evenly distribute them along the extrusion.

Proceed with Step 52

Your contributions are licensed under the open source Creative Commons license.