Step Type:

Drag to rearrange

If your bottom panel has a grommet dedicated to the Z Steppers, follow here, otherwise, go back to the previous Step.

Route the Z0 Stepper motor as shown

Route the Z1 Stepper motor as shown

Route the Z2 Stepper motor as shown

Feed all the cables through the bottom panel grommet.

Feed all the cables through the rear panel grommet and into the electronics enclosure

Connect all the cables to the octopus board as shown; Z0 - driver 5; Z1 - driver 6; Z2 - driver 7;

Use eighteen wire clips prepared in Step 61 at the marked locations. Evenly distribute them along the extrusion. Four of them should be used on the vertical rear Z extrusion.

Your contributions are licensed under the open source Creative Commons license.