Editing Step 1 —
Prepare your control board

Step Type:

Drag to rearrange

BIGTREETECH Octopus V1.1

Raspberry Pi

USB A to USB C Cable

Insert this jumper, allowing the board to receive power from the Raspberry Pi. Remove all other jumpers from the board.

5V Power supply - smartphone charger for example (minimum 3 AMP is recommended)

It is heavily recommended that you flash your board and make sure it is detected in the configurator before you plug in your stepper drivers and start connecting your wiring. - Check RatOs documentation

Remove the highlighted jumper as it will no longer be required.

If your board flashed successfully you can proceed with the guide.

Your contributions are licensed under the open source Creative Commons license.