Editing Step 47 —
Y Endstop Install

Step Type:

Drag to rearrange

Warning: Check your cables. Incorrect endstop wiring can damage your board.

Rat Rig Omron Y endstop

Endstop 3 wire cable - length: 2000 mm

Connect the JST3 connector to the shown slot on the octopus board.

Route the cable accordingly. Place the cables inside the extrusions to help route them.

Use four wire clips prepared in Step 46 at the marked locations. Evenly distribute them along the extrusion.

Your contributions are licensed under the open source Creative Commons license.