Step Type:

Drag to rearrange

This Step is only meant for the Hybrid and IDEX builds if you are building a V-Core 4 CoreXY skip this Step.

Route the Y1 Stepper motor cable as shown.

Route the Y2 Stepper motor cable as shown.

Connect the Y1 Stepper motor cable to the second slot available on the Octopus Board, counting from the bottom.

Connect the Y2 Stepper motor cable in the fifth slot available on the Octopus Board, counting from the bottom.

The stepper motor wire colour order does not matter if the cable was supplied in the V-Core 4 kit.

Use three wire clips prepared in Step 46 at the marked locations. Evenly distribute them along the extrusion.

Proceed with Step 52

Your contributions are licensed under the open source Creative Commons license.